Actions

Configuring a VLAN


This article applies to: Product Version
SBC 3.1, 3.3

After you create a virtual port, you must create a new VLAN.


To configure a VLAN

1. Select IP Interfaces from the navigation panel



2. Click the Virtual Ports tab.

  • Select a Virtual Port



3. Create a VLAN that uses this virtual port

  • Click Create new Host VLAN



4. Configure the new VLAN

Important Note

Vlans can be configured on the SBC in these cases:

  • Baremetal installation
  • VMware installation with Passthrough or SR-IOV network interfaces
  • VMware installation with a network interface using vlan ID 4095


Vlans should not be configured on the SBC in this case:

  • VMware installation with network interfaces using vlans from 1 to 4094

In this case, all interfaces on the SBC should be configured as untagged. Vlans are configured in the VMware port Groups.
Please check here: How to add VMware Network Interfaces

If VLANs must be configured, follow these steps:

  • Enter a name for the VLAN
  • If the port is to be used untagged, make sure Untagged is checked.
  • If the port is to be used with a 802.1Q tag, uncheck Untagged and enter a VLAN ID.
  • Click Create




OR




List of Parameters