ProSBC Maintenance Guide
Introduction
This article provides different procedures for maintaining your ProSBC.
ProSBC Verification
ProSBC Replacement
Backup your system configuration
If this is a 1+1 system, before proceeding with the procedure, make a backup of your configuration. Please follow this link: Backup procedure
Note: The database backup should be stored in a safe place
Setup a new ProSBC
Install a ProSBC using one of the following methods: ProSBC Installation
If the same product key is used, it needs to be reset - please contact TelcoBridges TB Support
Replacement of a standalone ProSBC
Go through the initial configuration and select "This unit is deployed as a stand-alone unit"
If the configuration database is available, restore it on the system: Restoring Database Procedure for v2.8 and up
Otherwise you will need to reconfigure the system: ProSBC Configuration
Replacement of a Primary ProSBC
Go through the initial configuration and select "As part of a redundant system"
Then select "The primary unit"
and "Get configuration from an existing secondary unit"
Replacement of a Secondary ProSBC
Go through the initial configuration and select "This unit is deployed as part of a redundant system" and select "The secondary unit". It will automatically get the configuration from the primary unit.