Actions

Allocating a SIP Open Network Access Point (NAP)


This article applies to: Product Version
SBC 3.1, 3.3

You must allocate a SIP NAP for your system. To create a new NAP:

1-Click NAPs in the navigation panel


2-Click Create New NAP


2-Create the new NAP

  • Enter a name for the NAP
  • Click Create


3-Verify that the NAP was successfully created message appears


Associate a SIP transport server with the new NAP

1-Select a SIP Transport Server from the Available list

2-Click "<<" to associate the SIP Transport Server with the NAP


Disable proxy address


Configure the Access Control List (ACL)

The ACL will determine which remote IP addresses will be allowed for incoming calls with this NAP.
Outgoing calls using this NAP will use the Proxy address in the NAP configuration. It will not use the IPs in the ACL.

1-Enter an IP/MASK (use 0.0.0.0/0 to accept any addresses)

2-Click "<<" to add in the list of Access Control

Associate a Port range with the new NAP

1-Select a port range from the Available list

2-Click "<<" to associate the Port range with the NAP


Associate a SIP Domain with the new NAP (optional)

1-Select a sip domain from the Available list

2-Click "<<" to associate the SIP Domain with the NAP


Configure settings for the following parameter groups as required

  • Registration Parameters
  • Authentication Parameters
  • Network Address Translation
  • SIP-I Parameters
  • Advanced Parameters

1- Click Save

Retrieved from "https://docs.telcobridges.com/w/index.php?title=Toolpack:Allocating_a_SIP_Open_Network_Access_Point_(NAP)_SBC_A&oldid=33904"