Applies to version: v3.1

Introduction

SIP Trunk Configuration Instruction with Sippy Example Configuration provides you with a step-by-step SIP Trunk Configuration of ProSBC with Sippy systems, using the Web Portal configuration tool. Complete general installation configuration steps, before you begin configuring your specific scenario. In this guide, FQDN (telcobridges.sippy.ca) configured in the Sippy server. Please check how to configure the SIP Trunk in Sippy for ProSBC from Adding ProSBC as a SIP Trunk in Sippy Server

Sippy SIP Trunk Example

Configuration Steps

(Step 1) Create IP Network	(Step 2) Create Protocol Stack	(Step 3) Create Call Route
Configuring an IP Virtual Port Configuring a VLAN Configuring IP Interfaces Create an IP port range	Create an IP port range Create a SIP stack Create a SIP transport server Modify profile Allocate a SIP NAP	Create a first call route

NAP Configuration

See Create SIP NAP
- Here, You must create two NAPs, one SIP NAP will be Sippy NAP and the other NAP will be for the SIP trunk provided by ITSP