Use Cases:TMG Performing M2UA Signaling Relay: Difference between revisions

Latest revision as of 14:09, 26 September 2022

In this scenario, all messages from TDM network are relayed to the IP network via Sigtran: M2UA. This can be used on a satellite link.

Note: This implementation, although based on standards, is proprietary. Normally, one end is the SG and the other is the MGC.

So in this use case, one of the TMGs simulates the MGC. All of this is transparent to the TDM devices interconnected over IP.

Configure TMG: M2UA Relay	Configure TMG: M2UA SG
MTP2-M2UA Configuration M2UA Configuration -> Node Type: M2UA-MTP2 Relay M2UA Link -> Bind the configured MTP2 link No need to configure MTP3 part	MTP2-M2UA Configuration M2UA Configuration -> Node Type: SG M2UA Link -> Bind the configured MTP2 link No need to configure MTP3 part

@@ Line 1: / Line 1: @@
-{{DISPLAYTITLE:TMG Performing M2UA Signaling Relay}}
+{{DISPLAYTITLE:TMG Performing MTP2 Signaling Relay over M2UA}}
 === '''''Applies to version(s): v2.9 and above''''' ===
@@ Line 19: / Line 19: @@
 |
 *[[Toolpack:Protocol_Stack_Settings_B#M2UA-MTP3-ISUP|MTP2-M2UA Configuration]]
-**M2UA Configuration -> Note Type: M2UA-MTP2 Relay
+**M2UA Configuration -> Node Type: M2UA-MTP2 Relay
 **M2UA Link -> Bind the configured MTP2 link
 **No need to configure MTP3 part
 |
 *[[Toolpack:Protocol_Stack_Settings_B#M2UA-MTP3-ISUP|MTP2-M2UA Configuration]]
-**M2UA Configuration -> Note Type: SG
+**M2UA Configuration -> Node Type: SG
 **M2UA Link -> Bind the configured MTP2 link
 **No need to configure MTP3 part
@@ Line 31: / Line 31: @@
 == References ==
 *[[Toolpack:Protocol_Stack_Settings_B#M2UA.3C-.3EMTP2_Relay|Configuring MTP2 to M2UA relay]]
+*[[M2UA_Satellite|M2UA Satellite Setings]]
 [[Category:Revise on Major]]