Toolpack v2.2:Configuring E1/T1/J1 Line Services

Line services correspond to the payload content of physical lines, therefore in order to configure a Line Service for a line interface, the line interfaces should already have been configured.

To create a line service

1. Select Line Interfaces from the navigation panel.

2. Click 'New Child Line Service' from the Line Interface Information panel.

3. Enter a name for the line service and click 'Create'.

4. The resulting line service is displayed in the information panel.

5. Repeat this procedure for each T1/E1/J1 line that you will use.

Verifying Status

To verify the status of a line service, either select Status from the Navigation panel or select the Status tab in the Information panel.