Creating SS7 Point Codes
Applies to version(s): v3.0
Point codes are used to define the adjacent and target networks so that calls are properly routed from one network to the next.
Create a destination point code (DPC):
1- Click Point Codes in the navigation panel
2- Click Create New Point Code
3- Configure the new point code:
- Enter a name for the point code
- Select a point code type (select type-specific parameters)
- Select a point code length (14, 16, 24 bits)
- Enter a point code. Either as bits, decimal, or hexadecimal.
- Click Create
Create an originating point code (OPC):
1- Configure the new point code:
- Enter a name for the point code
- Select a point code type (select type-specific parameters)
- Select a point code length (14, 16, 24 bits)
- Enter a point code. Either as bits, decimal, or hexadecimal.
- Click Create
4. Verify that the "MTP3 point code was successfully created" message appears, and the new point code appears in the Point Codes list
