Toolpack: Configuring RADIUS

Applies to version(s): v2.6

This page describes how to configure a RADIUS server for accounting in Toolpack v2.6.

1- Select Gateway -> Configurations from the navigation panel.

2- Verify that the box Use CDR behavior is checked.

3- Configure the CDR behavior in the CDR Options section:

• Select Radius CDR in the CDR Mode combo box.
• In the Radius server parameters section, set the Radius server address and port and Server secret fields.
• Click Save to save your changes.

4- Verify that the Gateway configuration was successfully updated. message appears.