Creating MTP3 Links
Applies to version(s): v3.0
After you create an MTP3 linkset, you associate it with MTP3 links. This is done because the MTP3 links are used to bind with either an MTP2, M2PA, or M2Ua link. They are connected in a one-to-one fashion.
To create an MTP3 link:
1- Click MTP3 in the navigation panel.
2- Select an MTP3 network.
3- Select an MTP3 linkset
4- Click Create New Mtp3 Link in the MTP3 linkset configuration window
5- Configure the new MTP3 link:
- Enter a name for the link
- Under Type of link to bind, select MTP2
- Select an MTP2 link
- Click Create
6- Verify that the "Mtp3Link was successfully created" message appears and that the link appears in the Mtp3 Link list.
List of Parameters
- Depending on the type chosen:
- Link Test Slc
- Libk Test Characters
- Priority
- Messages Priority
- C Link
- Discard Priority
- Flush Continue Flags
- Msg Q Len Prio0
- Msg Q Len Prio1
- Msg Q Len Prio2
- Msg Q Len Prio3
- Max Frame Length
- SLTM Maximum Retry
- T1 Timer
- T2 Timer
- T3 Timer
- T4 Timer
- T5 Timer
- T7 Timer
- T12 Timer
- T13 Timer
- T14 Timer
- T17 Timer
- T22 Timer
- T23 Timer
- BSN Request Timer
- Periodic SLTM timer
- SLTA Timer
- Layer 2 Connect Timer
- False Congestion Detect Timer
- Probation Link Oscillation Timer
- Suspension Link Oscillation Timer
- Link Referral Craft Timer
- Flow Control Request Timer
- Bind Confirmation Timer