Use Cases:Network Configuration

This article provides the steps required to complete the most common IP network configurations using the Web Portal.

One subnet, Two IP Addresses, Untagged

Configure IP Network A	Configure IP Network B
Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port. Configure the parameters as follows: IP Address: 192.168.4.10 Netmask: 255.255.255.0 Default gateway: 192.168.4.1 tbchangeip	Subnet B is untagged and bonded over VOIP0 and VOIP1 ports. When you Create an IP Virtual Port, configure it as follows: Name: vp VOIP U vLanId: Untagged Physical Ports: voip0, voip1 When you Create an IP Address, configure it as follows: Name: VOIP_UNTAG Virtual Ports: vp VOIP U IP Address: 192.168.4.20 Netmask: 255.255.255.0 Services: RTP, SIP, SIGTRAN

Configure SIP	Configure SIGTRAN	Configure H.248	Configure RADIUS
Configure SIP	Configure SIGTRAN	When you Configure H.248, set the following: Local IP Address and Public IP Address: 192.168.4.210 [Public IP or NAT public IP]	When you Configure RADIUS, set the following: Source IP interface: Any Radius -> Radius Server Public IP Address: Empty

[image of network configuration 2]

Configure IP Network A	Configure IP Network B
Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port. tbchangeip	Subnet B is untagged and is bonded over VOIP0 and VOIP1 ports. Create Virtual Port Create IP Address

Configure SIP	Configure SIGTRAN	Configure H.248	Configure RADIUS
Configure SIP	Configure SIGTRAN	Configure H.248	Configure RADIUS

[image of network configuration 3]

Configure IP Network A	Configure IP Network B
Create Virtual Port Create IP Address	Subnet B uses untag bonded over VOIP0 and VOIP1 ports Create Virtual Port Create IP Address

Configure SIP	Configure SIGTRAN	Configure H.248	Configure RADIUS
Configure SIP	Configure SIGTRAN	Configure H.248	Configure RADIUS