Configuring IP Interfaces: Difference between revisions
No edit summary |
No edit summary |
||
| Line 36: | Line 36: | ||
[[Image:Toolpack_v2.5_IP_Interface_Edited.png]] | [[Image:Toolpack_v2.5_IP_Interface_Edited.png]] | ||
'''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration: | '''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration: | ||
[[Image:Toolpack_v2.5_IP_Interface_Alert.png]] | [[Image:Toolpack_v2.5_IP_Interface_Alert.png]] | ||
==List of Parameters== | |||
* [[Parameter: Use DHCP|Use DHCP]] | |||
* [[Parameter: IP Address|IP Address]] | |||
* [[Parameter: Net Mask|Net Mask]] | |||
* [[Parameter: Gateway|Gateway]] | |||
Revision as of 17:19, 6 February 2011
The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
- IP Address
- Netmask
- Gateway
To configure a VoIP0 or VoIP1 port
1. Select IP Interfaces from the navigation panel:
2. Click 'Edit' from the IP Interfaces Information panel:
3. Configure the port:
- Indicate whether or not to use DHCP on this port
- Enter an IP address
- Enter a Netmask
- Enter a gateway address
- Click Save
Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets
4. The changes are displayed in the IP interfaces information panel:
IMPORTANT! The system will display the following notice, describing steps to apply your new configuration:
