Toolpack:Creating an M3UA Configuration (SGP) A: Difference between revisions
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
To set up your M3UA system on a signaling gateway process (SGP), you must first create a new M3UA configuration. | |||
In this configuration the SS7 MTP2 layer is replaced entirely by the SIGTRAN M3UA layer, and the MTP3 layer is extended over | |||
To create an M3UA configuration on an SGP: | To create an M3UA configuration on an SGP: | ||
Revision as of 13:35, 15 July 2010
To set up your M3UA system on a signaling gateway process (SGP), you must first create a new M3UA configuration. In this configuration the SS7 MTP2 layer is replaced entirely by the SIGTRAN M3UA layer, and the MTP3 layer is extended over
To create an M3UA configuration on an SGP:
1- Click M3UA in the navigation panel
2- Configure the M3UA service for SGP:
- Enter a name for the configuration
- Select Signaling Gateway Process (SGP) as the node type
- Click Create
3- Verify that the M3ua Cfg was successfully created message appears
