Toolpack:Reset HostRole A: Difference between revisions
No edit summary |
mNo edit summary |
||
| Line 1: | Line 1: | ||
{{DISPLAYTITLE:Resetting the Host Role}} | {{DISPLAYTITLE:Resetting the Host Role}} | ||
{| class="wikitable" | |||
|- | |||
|rowspan="3"|This article applies to: | |||
|'''Product''' | |||
|'''Version''' | |||
|- | |||
|Tmedia | |||
|2.8, 2.9, 2.10, 3.0, 3.2 | |||
|- | |||
|SBC | |||
|3.0, 3.1 | |||
|} | |||
If you need to change internal IP addresses, you must reset the host role settings of the unit. | If you need to change internal IP addresses, you must reset the host role settings of the unit. | ||
Revision as of 10:09, 11 November 2020
| This article applies to: | Product | Version |
| Tmedia | 2.8, 2.9, 2.10, 3.0, 3.2 | |
| SBC | 3.0, 3.1 |
If you need to change internal IP addresses, you must reset the host role settings of the unit.
To reset the host role, do the following:
1- Click Hosts in the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- Select Reset Host Role
- Click Apply Action
5- The Web Portal setup wizard is displayed. (You may need to refresh your web page to see this)
