Modify Fax Relay Profile F

Applies to version v3.0

To configure FAX Relay settings, do the following:

1- Click Fax Relay in the Editing Profile window, to display the customizable options.

2- Modify settings as required.

3- To configure NSE, check the Use NSE checkbox.

NOTE:

If NSE exchange is possible (negociated in the SDP), the switch to passthrough will happen in the RTP stream and no longer wiil occur with a SIP re-INVITE. This implementation of NSE currently only supports a switch to passthrough, which means that you can have NSE packets switching to T.38.

• Click Save

List of Parameters

Fax/Modem Relay

• Enable Fax/Modem Relay
• Detection Mode
• Relay Mode
• Modem vs. Fax distinction timeout
• Fax/Modem tones detection duration
• Enable early Fax/Modem tone detection
• Enable switching to FAX relay upon CNG tone
• Switch to passthrough upon Bell ANS

T.38 Parameters

• Use V.34
• Maximum Bit Rate
• Fill Bit Removal
• Redundancy Count
• Transmission level (-1dBm unit)

Fax/Modem Pass-through Parameters

• Detection Type
• Codec
• Jitter Buffer Depth
• Packet Duration
• Use NSE
• Support V.152 VBD
• Force V.152 VBD