Toolpack:Configuring VoIP Interfaces E

Applies to version(s): v3.0

The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

• IP Address
• Netmask
• Gateway

To configure a VoIP0 or VoIP1 port

1. Select IP Interfaces from the navigation panel:

2. Click the IP Interfaces tab.

• Click Create New IP Interface

3. Configure the IP port:

• Enter a name for the interface
• Select a service to use for the IP inteface
• Select a Virtual port from which IP packets will exit.
• Indicate whether or not to use DHCP to automatically get an IP address for this port. (selecting this option removes the need to enter and IP address, Netmask, and Gateway)
• Enter an IP address
• Enter a Netmask
• Enter a gateway address
• Click Save

Note: IP addresses using different virtual ports must be on different subnets.

4. The changes are displayed in the IP interfaces information panel:

5. Activate the configuration

• Select System from the navigation panel.
• Click Activate

6. You must reboot the adapters only if you are using the vlan from ports 3441 to 3450.

• Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter

It will take about 1.5 minutes to restart the unit.

List of Parameters

• Interface name
• Services to use
• Virtual port
• Use dynamic IP
• IP Address
• Netmask
• Gateway