Toolpack:Creating an M3UA SAP (IPSP) B: Difference between revisions

Revision as of 11:59, 28 September 2015

Applies to version(s): v2.8

Once an M3UA configuration is created, you must then create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.

To create an M3UA SAP:

1- Click M3UA in the navigation panel:

2- Click Create New M3ua Sap in the M3UA configuration panel

3- Configure the new SAP:

Enter a name for the SAP
Select an Unit to use
Select an SCTP source port
Click Create

4- Verify that the "M3ua Sap was successfully created" message appears

5- Associate an IP interface with the new SAP:

Select an available IP interface
Click the"<<" button to associate the interface with the SAP

List of Parameters

M3UA SAP Timers

SCTP SAP Advanced Parameters

Maximum data size

@@ Line 42: / Line 42: @@
 * [[Parameter: SCTP Adapter|SCTP Adapter]]
 * [[Parameter: SCTP Source Port|SCTP Source Port]]
+'''M3UA SAP Timers'''
+* [[Parameter: SCTP Primitive Timer|SCTP Primitive Timer]]
+* [[Parameter: SCTP Association Timer|SCTP Association Timer]]
+'''SCTP SAP Advanced Parameters'''
+* [[Parameter: Maximum data size|Maximum data size]]