Toolpack:Adding an Adapter D: Difference between revisions

Revision as of 16:21, 5 June 2015

Applies to version v2.8

When you receive a new system, at least one hardware configuration is available (by default) in the Toolpack application server. To add other hardware devices, use the Tmedia Web Portal.

Schematic showing 2 TMP6400 devices with an external server and a second machine with a web browser

In order to add one or more additional hardware devices to the Toolpack system configuration, their serial numbers must be registered with the Toolpack application server.

To add a hardware device:

1- Click Hardware Units in the navigation panel

2- Click Create New Unit, to add a new hardware device

3- Enter information for the following parameters:

Enter a name for the hardware device
Enter the serial number of the new hardware device (filling in the Serial Number field will cause auto-completion of the field to occur).
Select the appropriate hardware device from the Type field.
Enter the location in which the hardware device is installed.
Enter a meaningful description about the use or purpose of the hardware device.
Select Enabled from the Target State field.
Select the type of TDM lines that the hardware device will support.
Indicate if the device will operate as a backup in an N+1 configuration. If this is the first device being added, leave this field empty.
Provide the amount of time in seconds, that the system will wait for calls to complete before shutting down for an upgrade.
Click Create

NOTE The following image shows the N+1 Backup field set. This is done for the addition of a secondary device that will operate as the designated 1+1 backup in a 1+1 or N+1 group.

4- Verify that the Unit was successfully created message appears, and that the newly added hardware device appears in the Hardware List.

List of Parameters

Reduced Timer
- Start Threshold
- Stop Threshold

Congestion
- Start Threshold
- Stop Threshold

Critical Congestion
- Start Threshold
- Stop Threshold

@@ Line 60: / Line 60: @@
 * [[Parameter: Graceful Upgrade Timeout|Graceful Upgrade Timeout]]
-'''Advanced Parameters'''
+<div class="mw-collapsible mw-collapsed" data-collapsetext="Advanced Parameters" data-expandtext="Advanced Parameters" style="width: 400px;">
+{| class="wikitable"
+|-
 * [[Parameter: Enable management port redundancy|Enable management port redundancy]]
 * [[Parameter: Enable HTTP access|Enable HTTP access]]
@@ Line 119: / Line 121: @@
 * [[Parameter: Fixed density for ILBC 15 Kbps|Fixed density for ILBC 15 Kbps]]
 * [[Parameter: Fixed density for G722.2|Fixed density for G722.2]]
+|}
+</div>
 <div class="mw-collapsible mw-collapsed" data-collapsetext="Call Rate Limiting Parameters" data-expandtext="Call Rate Limiting Parameters" style="width: 400px;">