Actions

Toolpack:Adding an Adapter D: Difference between revisions

(Put call rate limiting parameters in collapsible section)
(remove extra /div)
Line 119: Line 119:
* [[Parameter: Fixed density for ILBC 15 Kbps|Fixed density for ILBC 15 Kbps]]
* [[Parameter: Fixed density for ILBC 15 Kbps|Fixed density for ILBC 15 Kbps]]
* [[Parameter: Fixed density for G722.2|Fixed density for G722.2]]
* [[Parameter: Fixed density for G722.2|Fixed density for G722.2]]


<div class="mw-collapsible mw-collapsed" data-collapsetext="Call Rate Limiting Parameters" data-expandtext="Call Rate Limiting Parameters" style="width: 400px;">
<div class="mw-collapsible mw-collapsed" data-collapsetext="Call Rate Limiting Parameters" data-expandtext="Call Rate Limiting Parameters" style="width: 400px;">
Line 134: Line 135:
* [[Parameter: Maximum total call burst|Maximum total call burst]]
* [[Parameter: Maximum total call burst|Maximum total call burst]]
|}
|}
</div>
</div>
</div>

Revision as of 16:19, 5 June 2015

Applies to version v2.8

When you receive a new system, at least one hardware configuration is available (by default) in the Toolpack application server. To add other hardware devices, use the Tmedia Web Portal.

Schematic showing 2 TMP6400 devices with an external server and a second machine with a web browser

In order to add one or more additional hardware devices to the Toolpack system configuration, their serial numbers must be registered with the Toolpack application server.


To add a hardware device:

1- Click Hardware Units in the navigation panel



2- Click Create New Unit, to add a new hardware device



3- Enter information for the following parameters:

  • Enter a name for the hardware device
  • Enter the serial number of the new hardware device (filling in the Serial Number field will cause auto-completion of the field to occur).
  • Select the appropriate hardware device from the Type field.
  • Enter the location in which the hardware device is installed.
  • Enter a meaningful description about the use or purpose of the hardware device.
  • Select Enabled from the Target State field.
  • Select the type of TDM lines that the hardware device will support.
  • Indicate if the device will operate as a backup in an N+1 configuration. If this is the first device being added, leave this field empty.
  • Provide the amount of time in seconds, that the system will wait for calls to complete before shutting down for an upgrade.
  • Click Create


NOTE The following image shows the N+1 Backup field set. This is done for the addition of a secondary device that will operate as the designated 1+1 backup in a 1+1 or N+1 group.

4- Verify that the Unit was successfully created message appears, and that the newly added hardware device appears in the Hardware List.


List of Parameters

Advanced Parameters


Retrieved from "https://docs.telcobridges.com/w/index.php?title=Toolpack:Adding_an_Adapter_D&oldid=18486"