M2PA: Difference between revisions
(add revise on major) |
|||
| Line 21: | Line 21: | ||
== TelcoBridges and M2PA == | == TelcoBridges and M2PA == | ||
TelcoBridges supports M2PA as part of its [[SIGTRAN]] implementation. | TelcoBridges supports M2PA as part of its [[SIGTRAN]] implementation. | ||
== Configuration == | |||
*[[Toolpack:Protocol_Stack_Settings_A#M2PA-MTP3-ISUP|SS7-M2PA configuration v2.8]] | |||
*[[Web_Portal_Tutorial_Guide_v2.7#SS7 ISUP|SS7 configuration v2.7]] | |||
== References == | == References == | ||
Revision as of 11:31, 3 March 2015
The M2PA (Message Transfer Part 2 Peer-to-Peer Adaptation Layer) is used to replace the MTP2 layer entirely. In contrast with M2UA, M2PA does not include MTP2 links between the 2 point codes. However, it still requires the MTP3 layer.
The following figures show 2 different configurations of M2PA:
FIGURE 1:
FIGURE 2:
The first figure includes a setup featuring the signaling gateway as an STP from the SS7 point of view.
TelcoBridges and M2PA
TelcoBridges supports M2PA as part of its SIGTRAN implementation.
Configuration
References
- Article at Protocols.com
- RFC 4165 Signaling System 7 (SS7) Message Transfer Part 2 (MTP2) - User Peer-to-Peer Adaptation Layer (M2PA)