Toolpack:Creating an M3UA SAP (IPSP) B: Difference between revisions
No edit summary |
|||
| Line 18: | Line 18: | ||
* Enter a '''name''' for the SAP | * Enter a '''name''' for the SAP | ||
* Select an ''' | * Select an '''Unit''' to use | ||
* Select an '''SCTP source port''' | * Select an '''SCTP source port''' | ||
* Click '''Create''' | * Click '''Create''' | ||
Revision as of 11:52, 22 September 2014
Applies to version(s): v2.8
Once an M3UA configuration is created, you must then create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.
To create an M3UA SAP:
1- Click M3UA in the navigation panel:
2- Click Create New M3ua Sap in the M3UA configuration panel
3- Configure the new SAP:
- Enter a name for the SAP
- Select an Unit to use
- Select an SCTP source port
- Click Create
4- Verify that the "M3ua Sap was successfully created" message appears
5- Associate an IP interface with the new SAP:
- Select an available IP interface
- Click the"<<" button to associate the interface with the SAP
