Toolpack:Adding M2PA Links B: Difference between revisions
| Line 29: | Line 29: | ||
** [[TTC]] | ** [[TTC]] | ||
* Set other features, as needed: | * Set other features, as needed: | ||
** '''Destination port''' (same value as the one configured on the destination side) | |||
** Number of '''SCTP Streams''' | ** Number of '''SCTP Streams''' | ||
* Click '''Create''' | * Click '''Create''' | ||
Revision as of 11:27, 18 September 2014
Applies to version(s): v2.8
After you create an M2PA service access point (SAP), you must create a new M2PA link. This is done from the M2PA SAP configuration window. To create an M2PA link:
1- Click M2PA in the navigation panel:
2- Select an M2PA SAP:
3- Click Create new M2pa link in the M2PA SAP configuration window:
4- Configure the new link:
- Enter a name for the link
- Select a protocol type:
- Set other features, as needed:
- Destination port (same value as the one configured on the destination side)
- Number of SCTP Streams
- Click Create
5- Enter a destination address in the appropriate box in the information panel:
- Click the "<<" button to add the destination address to the address list
6- Verify that the address has been added to the list, and that the "(your address) was successfully added" message appears (ex.: here the address is 190.0.0.0)
