Toolpack:Creating the M2PA Configuration B: Difference between revisions
(Created page with "=== '''''Applies to version(s): v2.7.''''' === {{DISPLAYTITLE:Creating the SCTP Configuration}} Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensure...") |
(This was a copy and paste of SCTP and a good part of it remained as SCTP. Note: the second and third images are taken from a 2.8 system.) |
||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.7.''''' === | === '''''Applies to version(s): v2.7.''''' === | ||
{{DISPLAYTITLE:Creating the | {{DISPLAYTITLE:Creating the M2PA Configuration}} | ||
To edit your system's | To edit your system's M2PA configuration: | ||
1- Select ''' | 1- Select '''M2PA''' from the navigation panel | ||
[[Image:M2pa_0.png]] | [[Image:M2pa_0.png]] | ||
| Line 12: | Line 12: | ||
* Make sure the box labelled '''Enabled''' is '''checked''' | * Make sure the box labelled '''Enabled''' is '''checked''' | ||
* Enter a '''name''' for the | * Enter a '''name''' for the M2PA service | ||
* Click '''Create''' | * Click '''Create''' | ||
[[Image: | [[Image:CreateM2pa_1.png]] | ||
3- Verify that the '''"Sctp Cfg was successfully created"''' message appears | 3- Verify that the '''"Sctp Cfg was successfully created"''' message appears | ||
[[Image: | [[Image:CreateM2pa_2.png]] | ||
Revision as of 10:44, 18 September 2014
Applies to version(s): v2.7.
To edit your system's M2PA configuration:
1- Select M2PA from the navigation panel
2- Configure the SCTP service
- Make sure the box labelled Enabled is checked
- Enter a name for the M2PA service
- Click Create
3- Verify that the "Sctp Cfg was successfully created" message appears
