Actions

Toolpack v2.5:Configuring IP Interfaces: Difference between revisions

 
(return page content to redirect page)
 
Line 1: Line 1:
#REDIRECT [[Configuring IP Interfaces]]
The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
 
*IP Address
*Netmask
*Gateway
 
<br>
 
== To configure a VoIP0 or VoIP1 port  ==
 
1. Select '''IP Interfaces''' from the navigation panel:
 
[[Image:Toolpack v2.5 Navigation Panel IP Interfaces.png]]
 
<br> 2. Click '''Edit''' from the IP Interfaces Information panel:
 
[[Image:Toolpack v2.5 Edit IP Interface.png]]
 
<br> 3. Configure the IP port:
 
*Indicate whether or not to use '''DHCP''' on this port
*Enter an '''IP address'''
*Enter a '''Netmask'''
*Enter a '''gateway address'''
*Click '''Save'''
 
'''Note:''' The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets. <br>
 
[[Image:Toolpack v2.5 Editing IP Interface.png]]
 
<br>
 
4. The changes are displayed in the IP interfaces information panel:
 
[[Image:Toolpack v2.5 IP Interface Edited.png]]
 
<br> '''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration:
 
[[Image:Toolpack v2.5 IP Interface Alert.png]]
 
<br>
 
5. Activate the configuration
 
Systems -&gt; Edit -&gt;&nbsp;Activate
 
 
 
6. Reboot the adapter (will drop active calls)
 
Status -&gt;&nbsp;Adapters -&gt; Click on the adapter Serial Number -&gt; Reboot adapter
 
It will take about 1.5 minutes to restart the unit.
 
== List of Parameters ==
 
*[[Parameter: Use DHCP|Use DHCP]]
*[[Parameter: IP Address|IP Address]]
*[[Parameter: Netmask|Netmask]]
*[[Parameter: Gateway|Gateway]]

Latest revision as of 10:08, 26 February 2013

The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

  • IP Address
  • Netmask
  • Gateway


To configure a VoIP0 or VoIP1 port

1. Select IP Interfaces from the navigation panel:


2. Click Edit from the IP Interfaces Information panel:


3. Configure the IP port:

  • Indicate whether or not to use DHCP on this port
  • Enter an IP address
  • Enter a Netmask
  • Enter a gateway address
  • Click Save

Note: The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets.


4. The changes are displayed in the IP interfaces information panel:


IMPORTANT! The system will display the following notice, describing steps to apply your new configuration:


5. Activate the configuration

Systems -> Edit -> Activate


6. Reboot the adapter (will drop active calls)

Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter

It will take about 1.5 minutes to restart the unit.

List of Parameters

Retrieved from "https://docs.telcobridges.com/w/index.php?title=Toolpack_v2.5:Configuring_IP_Interfaces&oldid=13101"