Toolpack:Creating an MTP3 Configuration A: Difference between revisions
No edit summary |
No edit summary |
||
| Line 18: | Line 18: | ||
[[Image:Toolpack_v2.5_Creating_MTP3.png]] | [[Image:Toolpack_v2.5_Creating_MTP3.png]] | ||
3- Verify that the '''Mtp3Cfg was successfully | 3- Verify that the '''Mtp3Cfg was successfully created''' message appears | ||
[[Image:Toolpack_v2.5_MTP3_Created.png]] | [[Image:Toolpack_v2.5_MTP3_Created.png]] | ||
Revision as of 15:59, 30 June 2010
Now that you have created originating and destination point codes (OPC and DPC), you must create an MTP3 configuration for your system. MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1- Select MTP3 from the navigation panel
2- Configure the new MTP3 service:
- Enter a name for the MTP3 configuration
- Make sure the Enabled and SSf Validation boxes are checked
- Select SP as the signaling point type
- Select a restart procedure
- Click Create
3- Verify that the Mtp3Cfg was successfully created message appears
