Toolpack v2.4:Create an MTP3 Configuration: Difference between revisions
| Line 11: | Line 11: | ||
*Enter a name for the MTP3 configuration | *Enter a name for the MTP3 configuration | ||
*Set Enabled status: | *Set Enabled status: | ||
*Select | *Select [[SP]] as the signalling point type | ||
*Set SSf validation: | *Set SSf validation: | ||
*Select a restart procedure: | *Select a restart procedure: | ||
*Set Transfer Restricted Required: | **None | ||
**[[ITU88]] | |||
**[[ITU92]] | |||
**[[ANSI]] | |||
*Set a value for "Transfer Restricted Required": | |||
*Click "Save" to finalize the configuration | *Click "Save" to finalize the configuration | ||
Revision as of 14:20, 8 January 2010
MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1. Select "MTP3" from the navigation panel:
2. Configure the new MTP3 service:
- Enter a name for the MTP3 configuration
- Set Enabled status:
- Select SP as the signalling point type
- Set SSf validation:
- Select a restart procedure:
- Set a value for "Transfer Restricted Required":
- Click "Save" to finalize the configuration
3. Verify that the "Mtp3Cfg was successfully updated" message appears:
