Toolpack:Starting Continuity Check ISUP A: Difference between revisions

Revision as of 14:00, 21 August 2020

Note: the option might not be available if the resources required for the test (tone generation and detection) are not available.

1- Select SS7->ISUP from the navigation panel

2- Click the Status tab and click on the appropriate ISUP Stack

3- Click the Interfaces tab and select the appropriate ISUP Interface

4- Click the Circuit Groups tab and select the appropriate Circuit Group

If you want to start a continuity check on all circuits of a circuit group:

If you want to start a continuity check on a specific circuit:

Click on the Circuits tab and select the circuit in the Cic column.
Select Yes forStart continuity check and click on Apply states
Click on Now to refresh the status and see the result of the test. Some of the following stats should be modified:
- Nb outgoing ccr success
- Nb outgoing ccr fail
- Last ccr result

@@ Line 7: / Line 7: @@
 - Select '''SS7->ISUP''' from the navigation panel
-- Click on the '''Status''' tab and click on the appropriate ISUP Stack
+- Click the '''Status''' tab and click on the appropriate ISUP Stack
-- Click on the '''Interfaces''' tab and select the appropriate ISUP Interface
+- Click the '''Interfaces''' tab and select the appropriate ISUP Interface
-- Click on the '''Circuit Groups''' tab and select the appropriate Circuit Group
+- Click the '''Circuit Groups''' tab and select the appropriate Circuit Group
 '''If you want to start a continuity check on all circuits of a circuit group:'''
 *Select '''Yes''' for'''Start continuity check''' and click on '''Apply states'''
-*Click on '''Now''' to refresh the status and see the result of the test. Some of the following stats should be modified:
+*Click '''Now''' to refresh the status and see the result of the test. Some of the following stats should be modified:
 **Total ccr success cnt
 **Total ccr fail cnt