Toolpack:Reset NetworkDevice A: Difference between revisions
No edit summary |
No edit summary |
||
| Line 26: | Line 26: | ||
* Click '''Apply Action''' | * Click '''Apply Action''' | ||
[[Image:Host_action_snapshot_network.png]] | [[Image:Host_action_snapshot_network.png]] | ||
After a few seconds, refresh the web interface and you will be brought back to the selection of network interfaces: [[TSBC-SW:WebPortal:Initial_Configuration|Initial Configuration]], Step 8 | After a few seconds, refresh the web interface and you will be brought back to the selection of network interfaces: [[TSBC-SW:WebPortal:Initial_Configuration|Initial Configuration]], Step 8 | ||
Revision as of 12:58, 31 July 2019
Applies to version(s) v3.0, v3.1
Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces.
To do so you must reset the network device role settings of the unit.
Note: this will reallocate the main network controller and stop the service for a few minutes
To reset the network device role, do the following:
1- Click Hosts in the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- In the Action drop down box select Change Network Devices Roles
- Click Apply Action
After a few seconds, refresh the web interface and you will be brought back to the selection of network interfaces: Initial Configuration, Step 8