Toolpack:Configuring VoIP Interfaces E: Difference between revisions
(Fix comment) |
(added screenshots) |
||
| Line 14: | Line 14: | ||
1. Select '''IP Interfaces''' from the navigation panel: | 1. Select '''IP Interfaces''' from the navigation panel: | ||
[[ | [[Image:CreateIpInterface_Tsbc_1.png]] | ||
<br> 2. Click the '''IP Interfaces''' tab. | <br> 2. Click the '''IP Interfaces''' tab. | ||
| Line 34: | Line 34: | ||
'''Note:''' IP addresses using different virtual ports must be on different subnets. <br> | '''Note:''' IP addresses using different virtual ports must be on different subnets. <br> | ||
[[ | [[Image:CreateIpInterface_Tsbc_1a.png]] | ||
<br> | <br> | ||
| Line 40: | Line 40: | ||
4. The changes are displayed in the IP interfaces information panel: | 4. The changes are displayed in the IP interfaces information panel: | ||
[[ | [[Image:CreateIpInterface_Tsbc_1b.png]] | ||
| Line 58: | Line 58: | ||
'''Note:''' in a 1+1 system, both units must be restarted. | '''Note:''' in a 1+1 system, both units must be restarted. | ||
== List of Parameters == | == List of Parameters == | ||
Revision as of 13:59, 24 October 2017
Applies to version(s): v3.0
The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
- IP Address
- Netmask
- Gateway
To configure a VoIP0 or VoIP1 port
1. Select IP Interfaces from the navigation panel:
2. Click the IP Interfaces tab.
- Click Create New IP Interface
3. Configure the IP port:
- Enter a name for the interface
- Select a service to use for the IP inteface
- Select a Virtual port from which IP packets will exit.
- Indicate whether or not to use DHCP to automatically get an IP address for this port. (selecting this option removes the need to enter and IP address, Netmask, and Gateway)
- Enter an IP address
- Enter a Netmask
- Enter a gateway address
- Click Save
Note: IP addresses using different virtual ports must be on different subnets.
4. The changes are displayed in the IP interfaces information panel:
5. Activate the configuration
Systems -> Edit -> Activate
6. It is necessary to reboot the adapters if you are using the vlan from 3441 to 3450 only.
Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter
It will take about 1.5 minutes to restart the unit.
Note: in a 1+1 system, both units must be restarted.