Actions

Use Cases:TMG Performing M2UA Signaling Relay: Difference between revisions

No edit summary
(LM Added Revise on Major (Link to configuration must adapt according to the version))
Line 31: Line 31:
== References ==
== References ==
*[[Toolpack:Protocol_Stack_Settings_B#M2UA.3C-.3EMTP2_Relay|Configuring MTP2 to M2UA relay]]
*[[Toolpack:Protocol_Stack_Settings_B#M2UA.3C-.3EMTP2_Relay|Configuring MTP2 to M2UA relay]]
[[Category:Revise on Major]]

Revision as of 14:06, 21 September 2017

Applies to version(s): v2.9 and above

In this scenario, all messages from TDM network are relayed to the IP network via Sigtran: M2UA. This can be used on a satellite link.




Note: This implementation, although based on standards, is proprietary. Normally, one end is the SG and the other is the MGC.

So in this use case, one of the TMGs simulates the MGC. All of this is transparent to the TDM devices interconnected over IP.


Configure TMG: M2UA Relay Configure TMG: M2UA SG
  • MTP2-M2UA Configuration
    • M2UA Configuration -> Note Type: M2UA-MTP2 Relay
    • M2UA Link -> Bind the configured MTP2 link
    • No need to configure MTP3 part
  • MTP2-M2UA Configuration
    • M2UA Configuration -> Note Type: SG
    • M2UA Link -> Bind the configured MTP2 link
    • No need to configure MTP3 part

References

Retrieved from "https://docs.telcobridges.com/w/index.php?title=Use_Cases:TMG_Performing_M2UA_Signaling_Relay&oldid=23711"