Toolpack:Reset HostRole A: Difference between revisions
No edit summary |
mNo edit summary |
||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s) v2.8, v.2.9''''' === | === '''''Applies to version(s) v2.8, v.2.9, 2.10''''' === | ||
{{DISPLAYTITLE:Resetting the Host Role}} | {{DISPLAYTITLE:Resetting the Host Role}} | ||
Revision as of 09:15, 27 September 2016
Applies to version(s) v2.8, v.2.9, 2.10
If you need to change the internal IP addresses of a gateway, you must reset the host role settings of the gateway.
To reset the host role, do the following:
1- Click Hosts in the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- Select Reset Host Role
- Click Apply Action
5- The Web Portal setup wizard is displayed. (You may need to refresh your web page to see this)
