Toolpack:Reset HostRole A: Difference between revisions
(Created page with "=== '''''Applies to version v2.8''''' === {{DISPLAYTITLE:Resetting the Host Role}} If you need to change the internal IP addresses of a gateway, you must reset the units' hos...") |
(Reset host role article) |
||
| Line 7: | Line 7: | ||
1- | 1- Select '''Hosts''' from the navigation panel. | ||
[[Image:HostRoleReset_0_A.png]] | [[Image:HostRoleReset_0_A.png]] | ||
2- Select | 2- Select the serial number of the unit. | ||
[[Image:HostRoleReset_1_A.png]] | [[Image:HostRoleReset_1_A.png]] | ||
3- | 3- Click the '''Status''' tab. | ||
[[Image:HostRoleReset_2_A.png]] | [[Image:HostRoleReset_2_A.png]] | ||
4- Select '''Reset Host Role''' | |||
* Click '''Apply Action''' | |||
[[Image:HostRoleReset_3_A.png]] | [[Image:HostRoleReset_3_A.png]] | ||
5- The Web Portal Unit Role Selection page is displayed. (You may need to refresh your web page to see this) | |||
[[Image:HostRoleReset_4_A.png]] | [[Image:HostRoleReset_4_A.png]] | ||
Revision as of 13:27, 2 February 2015
Applies to version v2.8
If you need to change the internal IP addresses of a gateway, you must reset the units' host role settings.
To reset the host role, do the following:
1- Select Hosts from the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- Select Reset Host Role
- Click Apply Action
5- The Web Portal Unit Role Selection page is displayed. (You may need to refresh your web page to see this)
