Modify Fax Relay Profile C: Difference between revisions
(2.8 profile article) |
No edit summary |
||
| Line 1: | Line 1: | ||
=== '''''Applies to version v2. | === '''''Applies to version v2.8''''' === | ||
{{DISPLAYTITLE:Modifying FAX Relay Profile Settings}} | {{DISPLAYTITLE:Modifying FAX Relay Profile Settings}} | ||
| Line 10: | Line 10: | ||
1- Click '''Fax Relay''' in the Editing Profile window, to display the customizable options. | 1- Click '''Fax Relay''' in the Editing Profile window, to display the customizable options. | ||
[[Image: | [[Image:ProfileVoipFaxRelay_0.png]] | ||
2- Modify settings as required. | 2- Modify settings as required. | ||
[[File: | [[File:ProfileVoipFaxRelay_1.png]] | ||
3- To configure NSE, check the '''Use NSE''' checkbox. | 3- To configure NSE, check the '''Use NSE''' checkbox. | ||
Revision as of 11:26, 6 November 2014
Applies to version v2.8
To configure FAX Relay settings, do the following:
1- Click Fax Relay in the Editing Profile window, to display the customizable options.
2- Modify settings as required.
3- To configure NSE, check the Use NSE checkbox.
NOTE:
If NSE exchange is possible (negociated in the SDP), the switch to passthrough will happen in the RTP stream and no longer wiil occur with a SIP re-INVITE. This implementation of NSE currently only supports a switch to passthrough, which means that you can have NSE packets switching to T.38.
- Click Save
List of Parameters
Fax/Modem Relay
- Fax Modem Relay:Enable Fax/Modem Relay
- Fax Modem Relay: Detection Mode
- Fax Modem Relay: Relay Mode
- Fax Modem Relay: Modem vs. Fax distinction timeout
- Fax Modem Relay: Fax/Modem tones detection duration
- Fax Modem Relay: Enable early Fax/Modem tone detection
- Fax Modem Relay: Enable switching to FAX relay upon CNG tone
T.38 Parameters
- T.38 Parameters: Use V.34
- T.38 Parameters: Maximum Bit Rate
- T.38 Parameters: Fill Bit Removal
- T.38 Parameters: Redundancy Count
- T.38 Parameters: Transmission level (-1dBm unit)
Fax/Modem Pass-through Parameters