Toolpack:Creating an M2PA SAP C: Difference between revisions
(New 2.8 article) |
|||
| Line 9: | Line 9: | ||
[[Image:CreateM2pa_0.png]] | [[Image:CreateM2pa_0.png]] | ||
2- Click '''Create new M2pa Sap''' | 2- Click '''Create new M2pa Sap''' | ||
| Line 35: | Line 36: | ||
[[Image:CreateM2paSap_3.png]] | [[Image:CreateM2paSap_3.png]] | ||
==List of Parameters== | ==List of Parameters== | ||
Revision as of 10:57, 18 September 2014
Applies to version(s): v2.8.
After you create an M2PA configuration, you must create a new M2PA service access point (SAP), which functions as the identifying label for endpoints in your network.
To create a new M2PA SAP:
1- Select M2PA from the navigation panel
2- Click Create new M2pa Sap
3- Configure the new M2PA SAP:
- Enter a name for the SAP
- Enter an SCTP source port for the SAP
- Click Create
4- Verify that the "M2pa Sap was successfully created" message appears
5- Associate IP interfaces
- Select an IP interface from the list in the information panel
- Click the "<<" button to add the selected IP interface. This is the outgoing route from the hardware adapter.
