Toolpack:Creating MTP2 Links B: Difference between revisions
(New 2.8 article) |
mNo edit summary |
||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.8''''' === | === '''''Applies to version(s): v2.8''''' === | ||
{{DISPLAYTITLE:Creating MTP2 Links}} | {{DISPLAYTITLE:Creating MTP2 Links}} | ||
Once you have created an MTP2 configuration, you must create the necessary MTP2 links. | |||
An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling. | An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling. | ||
To create an MTP2 link: | To create an MTP2 link: | ||
1- Click '''MTP2''' in the Navigation panel. | |||
[[Image:MTP2_0_A.png]] | |||
2- Click '''Create New Mtp2 Link''' in the MTP2 configuration window | |||
[[Image:Create_MTP2_Link_0.png]] | [[Image:Create_MTP2_Link_0.png]] | ||
3- Configure the new MTP2 link: | |||
* Enter a '''name''' for the new link | * Enter a '''name''' for the new link | ||
| Line 24: | Line 27: | ||
[[Image:Create_MTP2_Link_1.png]] | [[Image:Create_MTP2_Link_1.png]] | ||
4- Verify that the '''"MTP2 link was successfully created"''' message appears | |||
[[Image:Create_MTP2_Link_2.png]] | [[Image:Create_MTP2_Link_2.png]] | ||
Revision as of 09:30, 9 September 2014
Applies to version(s): v2.8
Once you have created an MTP2 configuration, you must create the necessary MTP2 links. An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling.
To create an MTP2 link:
1- Click MTP2 in the Navigation panel.
2- Click Create New Mtp2 Link in the MTP2 configuration window
3- Configure the new MTP2 link:
- Enter a name for the new link
- Select a connection mode
- Select a line service
- Assign timeslots to the link
- Select a protocol type
- Select a DPC length
- Select a timeslot rate
- Click Create
4- Verify that the "MTP2 link was successfully created" message appears
