M2UA: Difference between revisions
(add revise on major) |
|||
| Line 14: | Line 14: | ||
TelcoBridges supports M2UA as part of its [[SIGTRAN]] implementation. | TelcoBridges supports M2UA as part of its [[SIGTRAN]] implementation. | ||
== Configuration == | |||
*[[Toolpack:Protocol_Stack_Settings_A#M2UA|M2UA configuration v2.8]] | |||
*[[Web_Portal_Tutorial_Guide_v2.7#M2UA|M2UA configuration v2.7]] | |||
== References == | == References == | ||
Revision as of 11:37, 3 March 2015
The M2UA (Message Transfer Part 2 User Adaptation Layer) is used to interface MTP2 of the signaling gateway to the MTP3 of a media gateway controller. M2UA can also be seen as way to extend a MTP2 link. An M2UA link is always bound to an MTP2 link.
Here is a diagram of a setup using M2UA:
As you can see the M2UA layer can interface with either a NIF or MTP3 layer. Therefore M2UA has 2 modes of operation. Toolpack can configure M2UA in both modes.
TelcoBridges and M2UA
TelcoBridges supports M2UA as part of its SIGTRAN implementation.
Configuration
References
- Article at Protocols.com
- RFC 3331 Signaling System 7 (SS7) Message Transfer Part 2 (MTP2) - User Adaptation Layer