|
|
| Line 1: |
Line 1: |
| The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
| |
|
| |
|
| *IP Address
| | ==Management Port== |
| *Netmask
| |
| *Gateway
| |
|
| |
|
| <br>
| | [[TMG:Change_Management_IP_Address|Tmedia management port]] |
|
| |
|
| == To configure a VoIP0 or VoIP1 port == | | ==VoIP Port== |
|
| |
|
| 1. Select '''IP Interfaces''' from the navigation panel:
| | [[Change_VoIP_Interface_IP_Address|Tmedia VoIP port]] |
| | |
| [[Image:Toolpack v2.5 Navigation Panel IP Interfaces.png]] | |
| | |
| <br> 2. Click '''Edit''' from the IP Interfaces Information panel:
| |
| | |
| [[Image:Toolpack v2.5 Edit IP Interface.png]]
| |
| | |
| <br> 3. Configure the IP port:
| |
| | |
| *Indicate whether or not to use '''DHCP''' on this port
| |
| *Enter an '''IP address'''
| |
| *Enter a '''Netmask'''
| |
| *Enter a '''gateway address'''
| |
| *Click '''Save'''
| |
| | |
| '''Note:''' The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets. <br>
| |
| | |
| [[Image:Toolpack v2.5 Editing IP Interface.png]]
| |
| | |
| <br>
| |
| | |
| 4. The changes are displayed in the IP interfaces information panel:
| |
| | |
| [[Image:Toolpack v2.5 IP Interface Edited.png]]
| |
| | |
| <br> '''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration:
| |
| | |
| [[Image:Toolpack v2.5 IP Interface Alert.png]]
| |
| | |
| <br>
| |
| | |
| 5. Activate the configuration
| |
| | |
| Systems -> Edit -> Activate
| |
| | |
| | |
| | |
| 6. Reboot the adapter (will drop active calls)
| |
| | |
| Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter
| |
| | |
| It will take about 1.5 minutes to restart the unit.
| |
| | |
| == List of Parameters ==
| |
| | |
| *[[Parameter: Use DHCP|Use DHCP]]
| |
| *[[Parameter: IP Address|IP Address]]
| |
| *[[Parameter: Netmask|Netmask]]
| |
| *[[Parameter: Gateway|Gateway]]
| |