|
|
| (3 intermediate revisions by 3 users not shown) |
| Line 1: |
Line 1: |
| The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
| | {{DISPLAYTITLE:Configuring IP Interfaces}} |
|
| |
|
| *IP Address
| | ==Management Port== |
| *Netmask
| |
| *Gateway
| |
|
| |
|
| <br/>
| | [[TMG:Change_Management_IP_Address|Tmedia management port]] |
| == To configure a VoIP0 or VoIP1 port ==
| |
|
| |
|
| 1. Select '''IP Interfaces''' from the navigation panel:
| | ==VoIP Port== |
|
| |
|
| [[Image:Toolpack_v2.5_Navigation_Panel_IP_Interfaces.png]] | | [[Change_VoIP_Interface_IP_Address|Tmedia VoIP port]] |
| | |
| <br/>
| |
| 2. Click '''Edit''' from the IP Interfaces Information panel:
| |
| | |
| [[Image:Toolpack_v2.5_Edit_IP_Interface.png]]
| |
| | |
| <br/>
| |
| 3. Configure the IP port:
| |
| | |
| * Indicate whether or not to use '''DHCP''' on this port
| |
| * Enter an '''IP address'''
| |
| * Enter a '''Netmask'''
| |
| * Enter a '''gateway address'''
| |
| * Click '''Save'''
| |
| | |
| '''Note:''' The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets.
| |
| <br/>
| |
| | |
| [[Image:Toolpack_v2.5_Editing_IP_Interface.png]]
| |
| | |
| <br/>
| |
| | |
| 4. The changes are displayed in the IP interfaces information panel:
| |
| | |
| [[Image:Toolpack_v2.5_IP_Interface_Edited.png]]
| |
| | |
| | |
| '''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration:
| |
| | |
| [[Image:Toolpack_v2.5_IP_Interface_Alert.png]]
| |
| | |
| | |
| ==List of Parameters==
| |
| | |
| * [[Parameter: Use DHCP|Use DHCP]]
| |
| * [[Parameter: IP Address|IP Address]]
| |
| * [[Parameter: Netmask|Netmask]]
| |
| * [[Parameter: Gateway|Gateway]]
| |