Parameter: Call Control: Difference between revisions
(Created page with 'The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter can …') |
(minor corrections) |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter | The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter has the following values: | ||
* Incoming | * Incoming: Circuits are always controlled by the remote end. Calls will not be sent to these circuits. | ||
* Outgoing | * Outgoing: Circuits are always controlled by TMG. Inbound calls from these circuits will be rejected. | ||
* Bothway | * Bothway: Circuits work for both inbound and outbound calls. | ||
* Controlled | * Controlled: Same as Incoming | ||
* Controlling | * Controlling: Same as Outgoing | ||
[[Category:Parameters]] | |||
Latest revision as of 14:12, 21 December 2015
The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter has the following values:
- Incoming: Circuits are always controlled by the remote end. Calls will not be sent to these circuits.
- Outgoing: Circuits are always controlled by TMG. Inbound calls from these circuits will be rejected.
- Bothway: Circuits work for both inbound and outbound calls.
- Controlled: Same as Incoming
- Controlling: Same as Outgoing