Toolpack:Reset NetworkDevice A: Difference between revisions
No edit summary |
No edit summary |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{DISPLAYTITLE:Resetting the Network Device Role}} | {{DISPLAYTITLE:Resetting the Network Device Role}} | ||
{| class="wikitable" | |||
|- | |||
|rowspan="3"|This article applies to: | |||
|'''Product''' | |||
|'''Version''' | |||
|- | |||
|SBC | |||
|3.1, 3.3 | |||
|} | |||
Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces. | Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces. | ||
| Line 26: | Line 34: | ||
* Click '''Apply Action''' | * Click '''Apply Action''' | ||
[[Image:Host_action_snapshot_network.png]] | [[Image:Host_action_snapshot_network.png]] | ||
After a few seconds, refresh the web interface and you will be brought back to the selection of network interfaces: [[TSBC-SW:WebPortal:Initial_Configuration|Initial Configuration]], Step 8 | After a few seconds, refresh the web interface and you will be brought back to the selection of network interfaces: [[TSBC-SW:WebPortal:Initial_Configuration|Initial Configuration]], Step 8 | ||
Latest revision as of 10:12, 15 June 2024
| This article applies to: | Product | Version |
| SBC | 3.1, 3.3 |
Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces.
To do so you must reset the network device role settings of the unit.
Note: this will reallocate the main network controller and stop the service for a few minutes
To reset the network device role, do the following:
1- Click Hosts in the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- In the Action drop down box select Change Network Devices Roles
- Click Apply Action
After a few seconds, refresh the web interface and you will be brought back to the selection of network interfaces: Initial Configuration, Step 8