|
|
| (14 intermediate revisions by 4 users not shown) |
| Line 1: |
Line 1: |
| [[Image:Diagram-mtp3-layer.jpg|thumb|300px|Diagram of the MTP3 layer]] | | #REDIRECT[[MTP3]] |
| The MTP3 layer provides message routing between signaling points in an [[SS7]] network. This layer routes traffic away from failed links and signaling points and controls traffic when congestion occurs. The MTP3 layer contains a Userpart that represents a specific protocol variant.
| |
| | |
| A conceptual illustration of the MTP3 layer is provided on the right.
| |
| | |
| | |
| == TelcoBridges and MTP3 ==
| |
| TelcoBridges supports the MTP3 layer in its SS7 signaling stack. It also provides the following functionality:
| |
| *Up to 64 [[Originating point code|OPCs]] per system
| |
| *Up to 64 [[Linkset|linksets]] per system
| |
| *Point code sharing by multiple devices with external [[Toolpack]] control
| |
| | |
| | |
| === Supported MTP3 variants ===
| |
| *ANSI (used for ANSI88 and ANSI92)
| |
| *ANSI96 (used for ANSI96 and Telcordia)
| |
| *ITU (used for ITU88, ITU92, ITU97, Q767, Singapore and ETSI)
| |
| *China, GF001-9001
| |
| | |
| | |
| == Related actions ==
| |
| *[[Toolpack:Create an MTP3 Configuration|Create an MTP3 Configuration]]
| |
| *[[Toolpack:Create an MTP3 Network|Create an MTP3 Network]]
| |
| **[[Toolpack:Create an MTP3 Point Code|Create an MTP3 Point Code]]
| |
| **[[Toolpack:Create an MTP3 Linkset|Create an MTP3 Linkset]]
| |
| **[[Toolpack:Create an MTP3 Route|Create an MTP3 Route]]
| |
| *[[Toolpack:Status Menus:SS7 MTP3|Verify status of SS7 MTP3 elements]]
| |
| | |
| | |
| == References ==
| |
| *[http://en.wikipedia.org/wiki/Message_Transfer_Part Wikipedia article]
| |
| | |
| | |
| [[Category:Glossary]]
| |