Toolpack:Configuring IP Interfaces v2.3: Difference between revisions
(Added : Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 5: | Line 5: | ||
*Gateway | *Gateway | ||
== To configure a VoIP0 or VoIP1 port == | == To configure a VoIP0 or VoIP1 port == | ||
'''1. Select IP Interfaces from the navigation panel.''' | '''1. Select IP Interfaces from the navigation panel.''' | ||
<br> [[Image:Configuring IP Interfaces V2.3 0.jpg|150px]] | |||
<br> '''2. Click 'Edit' from the IP Interfaces Information panel.''' | |||
<br> [[Image:Configuring IP Interfaces V2.3 1.jpg|600px]] | |||
''' | <br> '''3. Enter an IP address, a Netmask, and a gateway address.''' | ||
* | |||
''Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets'' | |||
<br> [[Image:Configuring IP Interfaces V2.3 2.jpg|600px]] | |||
''' | <br> '''4. The changes are displayed in the IP interfaces information panel.''' | ||
<br> [[Image:Configuring IP Interfaces V2.3 3.jpg|600px]] | |||
'''Note''': To apply the IP configuration change, activate the current configuration, and then reboot the adapter. | |||
''' | |||
Latest revision as of 14:24, 31 March 2010
The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:
- IP Address
- Netmask
- Gateway
To configure a VoIP0 or VoIP1 port
1. Select IP Interfaces from the navigation panel.
2. Click 'Edit' from the IP Interfaces Information panel.
3. Enter an IP address, a Netmask, and a gateway address.
Note: the IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets
4. The changes are displayed in the IP interfaces information panel.
Note: To apply the IP configuration change, activate the current configuration, and then reboot the adapter.