Toolpack v2.4:Create an MTP3 Configuration: Difference between revisions
No edit summary |
|||
| (6 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[MTP3 | [[MTP3_Layer|MTP3]] provides message routing between signaling points in an SS7 network. | ||
==To create an MTP3 configuration:== | ==To create an MTP3 configuration:== | ||
| Line 10: | Line 10: | ||
*Enter a name for the MTP3 configuration | *Enter a name for the MTP3 configuration | ||
*Select | *Set Enabled status: | ||
*Click "Save" to | *Select SP as the signalling point type | ||
*Set SSf validation: | |||
*Select a restart procedure: | |||
**None | |||
**ITU88 (protocol variant) | |||
**ITU92 (protocol variant) | |||
**[[ANSI]] | |||
*Set a value for "Transfer Restricted Required": | |||
*Click "Save" to finalize the configuration | |||
[[Image:Web_Portal_v2.4_Creating_MTP3.png|700px]] | [[Image:Web_Portal_v2.4_Creating_MTP3.png|700px]] | ||
Latest revision as of 10:32, 16 January 2010
MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1. Select "MTP3" from the navigation panel:
2. Configure the new MTP3 service:
- Enter a name for the MTP3 configuration
- Set Enabled status:
- Select SP as the signalling point type
- Set SSf validation:
- Select a restart procedure:
- None
- ITU88 (protocol variant)
- ITU92 (protocol variant)
- ANSI
- Set a value for "Transfer Restricted Required":
- Click "Save" to finalize the configuration
3. Verify that the "Mtp3Cfg was successfully updated" message appears:
