Toolpack v2.4:Edit the SCTP Configuration: Difference between revisions
| (2 intermediate revisions by the same user not shown) | |||
| Line 10: | Line 10: | ||
*Enter a name for the SCTP service | *Enter a name for the SCTP service | ||
*Select an appropriate service type | *Select an appropriate service type: | ||
**[[RAW IP]] | |||
**[[UDP IP]] | |||
*Configure any necessary advanced parameters | *Configure any necessary advanced parameters | ||
*Click "Save" | *Click "Save" to store the configuration | ||
[[Image:Web_Portal_v2.4_Editing_SCTP.png|700px]] | [[Image:Web_Portal_v2.4_Editing_SCTP.png|700px]] | ||
Latest revision as of 13:23, 8 January 2010
Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages.
To edit the SCTP configuration:
1. Select "SCTP" from the navigation panel:
2. Configure the SCTP service:
- Enter a name for the SCTP service
- Select an appropriate service type:
- Configure any necessary advanced parameters
- Click "Save" to store the configuration
3. Verify that the "Sctp Cfg was successfully updated" message appears:
