Toolpack v2.4:Edit the M2PA Configuration: Difference between revisions
(Created page with '==To create an M2PA configuration:== '''1. Select "M2PA" from the navigation panel:''' Image:Web_Portal_v2.4_Navigation_Panel_M2PA.png '''2. Configure the new M2PA service…') |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[M2PA]] replaces the MTP2 layer entirely; however, it still requires the MTP3 layer. | |||
==To create an M2PA configuration:== | ==To create an M2PA configuration:== | ||
| Line 9: | Line 11: | ||
*Enter a name for the M2PA configuration | *Enter a name for the M2PA configuration | ||
*Change the "Timers" setting, if necessary | *Change the "Timers" setting, if necessary | ||
*Click "Create" to | *Click "Create" to finalize the configuration | ||
[[Image:Web_Portal_v2.4_Creating_M2PA.png|700px]] | [[Image:Web_Portal_v2.4_Creating_M2PA.png|700px]] | ||
Latest revision as of 12:45, 26 December 2009
M2PA replaces the MTP2 layer entirely; however, it still requires the MTP3 layer.
To create an M2PA configuration:
1. Select "M2PA" from the navigation panel:
2. Configure the new M2PA service:
- Enter a name for the M2PA configuration
- Change the "Timers" setting, if necessary
- Click "Create" to finalize the configuration
3. Verify that the "M2pa Cfg was successfully created" message appears:
