Toolpack v2.3:Create a Protection Line SONET/SDH Interface: Difference between revisions
(Created page with '== To create a protection line interface == '''1. Select Line Interfaces from the navigation panel.''' 150px '''2. Click 'Create New Line …') |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 3: | Line 3: | ||
'''1. Select Line Interfaces from the navigation panel.''' | '''1. Select Line Interfaces from the navigation panel.''' | ||
[[Image: | [[Image:Navigation_Panel_v2.3_Line_Interfaces.png]] | ||
| Line 9: | Line 9: | ||
[[Image: | [[Image:Web_Portal_v2.3_Create_New_Line_Interface.png|700px]] | ||
Latest revision as of 13:22, 25 October 2009
To create a protection line interface
1. Select Line Interfaces from the navigation panel.
2. Click 'Create New Line Interface' from the Information panel.
3. To create a secondary or switchover OC3 line interface:
- Enter a name for the line interface, and set the Line Type to OC3
- Select the remaining local index, which corresponds to fibre number two and set TX State to Laser On
- Set the Channel to protection
- Click Create
4. Verify that the two newly added interfaces are listed.
