SBC Maintenance: Difference between revisions
(Created page with "{{DISPLAYTITLE:ProSBC Maintenance Guide}} This article shows different procedures for maintaining your ProSBC. == ProSBC Verification == *Centos_Check_Disk_Space|Check Dis...") |
No edit summary |
||
| (2 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
{{DISPLAYTITLE:ProSBC Maintenance Guide}} | {{DISPLAYTITLE:ProSBC Maintenance Guide}} | ||
This article | = '''Please refer to this page instead:''' [https://docs.prosbc.com/maintenance-and-troubleshooting/maintenance-guide ProSBC Maintenance] = | ||
<br /><br /><br /><br /> | |||
==Introduction== | |||
This article provides different procedures for maintaining your ProSBC. | |||
== ProSBC Verification == | == ProSBC Verification == | ||
| Line 10: | Line 15: | ||
== ProSBC Replacement == | == ProSBC Replacement == | ||
=== Backup your system configuration === | === Backup your system configuration === | ||
If this is a 1+1 system, before proceeding with the procedure, | If this is a 1+1 system, before proceeding with the procedure, make a backup of your configuration. Please follow this link: [[Troubleshooting_Toolpack#System_configuration_backup|Backup procedure]]<br> | ||
'''Note:''' The database backup should be stored in a safe place | '''Note:''' The database backup should be stored in a safe place | ||
Latest revision as of 16:20, 17 November 2025
Please refer to this page instead: ProSBC Maintenance
Introduction
This article provides different procedures for maintaining your ProSBC.
ProSBC Verification
ProSBC Replacement
Backup your system configuration
If this is a 1+1 system, before proceeding with the procedure, make a backup of your configuration. Please follow this link: Backup procedure
Note: The database backup should be stored in a safe place
Setup a new ProSBC
Install a ProSBC using one of the following methods: ProSBC Installation
If the same product key is used, it needs to be reset - please contact TelcoBridges TB Support
Replacement of a standalone ProSBC
Go through the initial configuration and select "This unit is deployed as a stand-alone unit"
If the configuration database is available, restore it on the system: Restoring Database Procedure for v2.8 and up
Otherwise you will need to reconfigure the system: ProSBC Configuration
Replacement of a Primary ProSBC
Go through the initial configuration and select "As part of a redundant system"
Then select "The primary unit"
and "Get configuration from an existing secondary unit"
Replacement of a Secondary ProSBC
Go through the initial configuration and select "This unit is deployed as part of a redundant system" and select "The secondary unit". It will automatically get the configuration from the primary unit.
