Toolpack:Starting Continuity Check ISUP A

This article applies to:	Product	Version
	Tmedia	3.0, 3.2, 3.3

Note: the option might not be available if the resources required for the test (tone generation and detection) are not available.

1- Select SS7->ISUP from the navigation panel

2- Click the Status tab and click on the appropriate ISUP Stack

3- Click the Interfaces tab and select the appropriate ISUP Interface

4- Click the Circuit Groups tab and select the appropriate Circuit Group

If you want to start a continuity check on all circuits of a circuit group:

• Select Yes forStart continuity check and click on Apply states
• Click Now to refresh the status and see the result of the test. Some of the following stats should be modified:
  • Total ccr success cnt
  • Total ccr fail cnt
  • Last ccr unknown cnt
  • Last ccr in progress cnt
  • Last ccr success cnt
  • Last ccr fail cnt
  • Last ccr error cnt

If you want to start a continuity check on a specific circuit:

• Click on the Circuits tab and select the circuit in the Cic column.
• Select Yes forStart continuity check and click on Apply states
• Click on Now to refresh the status and see the result of the test. Some of the following stats should be modified:
  • Nb outgoing ccr success
  • Nb outgoing ccr fail
  • Last ccr result