M2PA: Difference between revisions

Latest revision as of 09:30, 22 June 2023

The Message Transfer Part 2 Peer-to-Peer Adaptation Layer (M2PA) is used to replace the MTP2 layer entirely. In contrast with M2UA, M2PA does not include MTP2 links between the two point codes; however, it still requires the MTP3 layer.

The following figures show two different configurations of M2PA:

FIGURE 1:

FIGURE 2:

The first figure includes a setup featuring the signaling gateway as an STP, from the SS7 point of view.

TelcoBridges and M2PA

TelcoBridges supports M2PA as part of its SIGTRAN implementation.

Configuration

References

Article at Protocols.com
RFC 4165 Signaling System 7 (SS7) Message Transfer Part 2 (MTP2) - User Peer-to-Peer Adaptation Layer (M2PA)

Revision as of 11:04, 13 June 2023 (view source) Luc Morissette (talk \| contribs) (→‎Configuration) ← Older edit		Latest revision as of 09:30, 22 June 2023 (view source) Allyntree (talk \| contribs) No edit summary
(2 intermediate revisions by the same user not shown)
Line 1:		Line 1:
	The ~~M2PA (~~Message Transfer Part 2 Peer-to-Peer Adaptation Layer) is used to replace the [[MTP2 Layer\|MTP2]] layer entirely. In contrast with [[M2UA]], M2PA does not include MTP2 links between the two point codes~~. However~~, it still requires the [[MTP3 Layer\|MTP3]] layer.		{{DISPLAYTITLE:M2PA}}
			The ''Message Transfer Part 2 Peer-to-Peer Adaptation Layer'' (M2PA) is used to replace the [[MTP2 Layer\|MTP2]] layer entirely. In contrast with [[M2UA]], M2PA does not include MTP2 links between the two point codes; however, it still requires the [[MTP3 Layer\|MTP3]] layer.