Configure Fax Passthrough B: Difference between revisions
Clod Patry (talk | contribs) (creating page for 2.6) |
mNo edit summary |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{DISPLAYTITLE:Configure Fax Passthrough}} | |||
{| class="wikitable" | |||
|- | |||
|rowspan="2"|This article applies to: | |||
|'''Product''' | |||
|'''Version''' | |||
|- | |||
|Tmedia | |||
|2.7 | |||
|} | |||
To enable passthrough, follow these steps: | To enable passthrough, follow these steps: | ||
<pre> | <pre> | ||
| Line 10: | Line 21: | ||
[[Image: | [[Image:profile_passthru_silence_v27.png]] | ||
Latest revision as of 10:51, 9 September 2022
| This article applies to: | Product | Version |
| Tmedia | 2.7 |
To enable passthrough, follow these steps:
1. Make sure "Enable Fax/Modem Relay" is enabled. 2. Make sure "Detection Mode" is Standard. 3. Make sure "Relay Mode" is Passthrough. 4. Make sure "Enable switching to FAX relay upon CNG tone" is checked. 5. Make sure "Detection type" is "Silence Suppression off" 6. Make sure the Codec is the same as the remote end.
