Actions

Configure Fax Passthrough A: Difference between revisions

(adding header)
mNo edit summary
 
(4 intermediate revisions by 2 users not shown)
Line 1: Line 1:
=== '''''Applies to version(s): v2.7.''''' ===
{{DISPLAYTITLE:Configure Fax Passthrough}}
{{DISPLAYTITLE:Configure Fax Passthrough}}


To enable passthrough, follow these steps:
{| class="wikitable"
<pre>
|-
1. Make sure "Enable Fax/Modem Relay" is enabled.
|rowspan="2"|This article applies to:
2. Make sure "Detection Mode" is Standard.
|'''Product'''
3. Make sure "Relay Mode" is Passthrough.
|'''Version'''
4. Make sure "Enable switching to FAX relay upon CNG tone" is checked.
|-
5. Make sure "Detection type" is "Silence Suppression off"
|Tmedia
6. Make sure the Codec is the same as the remote end.
|2.6, 2.7
</pre>
|}


'''To enable passthrough:'''


[[Image:profile_passthru_silence_v27.png]]
1. Select '''Profiles''' from the navigation menu.
 
[[Image:Profiles_0.png]]
 
 
2. Set '''Detection Mode''' to Standard.
 
3. Set '''Relay Mode''' to Passthrough.
 
4. Check the '''Switch to FAX relay upon CNG tone''' option.
 
5. Set '''Detection type''' to "Silence Suppression off"
 
6. Verify the the Codec is the same as the remote end.
 
 
[[Image:Profile_passthru_silence_v26.png]]

Latest revision as of 10:50, 9 September 2022


This article applies to: Product Version
Tmedia 2.6, 2.7

To enable passthrough:

1. Select Profiles from the navigation menu.


2. Set Detection Mode to Standard.

3. Set Relay Mode to Passthrough.

4. Check the Switch to FAX relay upon CNG tone option.

5. Set Detection type to "Silence Suppression off"

6. Verify the the Codec is the same as the remote end.


Retrieved from "https://docs.telcobridges.com/w/index.php?title=Configure_Fax_Passthrough_A&oldid=31948"